Spectrum-controls 1762sc-IF8U User Manual download pdf (Page 23)

Chapter 3: Configuring the 1762sc-IF8u for RSLogix 500 3-3

User'sManualPub.0300243‐02Rev.B

5.) Repeat steps 1 through 4 for additional modules.

Section 3.4

Module

Configuration

The IF8u is configured using the output data table within RSLogix 500 and dip-switch

settings located on the circuit board.

3.4.1 Dip-Switch Configuration

There are 8 dip-switches located on the circuit board of the IF8u module. The switches

are used to configure the correct input path (i.e. Current or Non-Current). Refer to the

diagram below for proper dip-switch settings.

3.4.2 Output Data File (Configuration Data)

The output data file is used to configure the advanced settings of the module including

input type, data format, filter settings, etc. Use the addressing scheme below to locate the

1 2 3 4 5 6 7 8

Non-Current

Current

Channel #

Figure 3-2 (Dip-Switch Settings)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 37 38

No comments

Spectrum-controls 1762sc-IF8U User Manual Page 23